Recent content by gopman

Yes, that's exactly what I saw. But I don't have pedal regen enabled. Only the digital aux buttons turn on regen, and the digital aux values weren't set to regen when the problem was happening. Since the CA was showing that it was outputting a high throttle out to the baserunner, but the was...

I built a custom logger with a DC-DC buck regulator and a tiny serial to SDCARD module from Amazon (I think). I was using Imperial units. The file is directly what the CA logs, so fixed columns with spaces between them.

That doesn't appear to be the issue. If you look at the spreadsheets, the CA is providing high ThO voltage to the Baserunner, but the CA isn't reporting any current in the motor. Also, when the motor cuts out, it stays off until I power cycle the system. Also - there is often negative...

Your assumptions sound correct. I think I highlighted all or most of the problem areas. The negative temps are very interesting, I think. They often correspond with the problem. So - I was hoping someone from Grin might take a look and see if that sounds familiar or if it points to where the...

Thanks for the info on Down Rate. Here are the details: It's an all Grin setup with the CA, Baserunner, All-axle motor, PAS, UP/Down Digital Aux in (to control assist level). It's set up to only provide assist while pedaling with the assist level set by the power selected with the digital aux...

I'm debugging an issue with my bike - which has a Cycle Analyst running 3.2b3, a BaseRunner, and an all-axle motor. I'll post more details after I do some analysis, but there's one thing that I didn't see in the manual: A couple of times when my motor cut out, I had what I think was a "DR_" on...