jhoexp

Downhill is comfortable only going down the hill. On flat it is useless, as the front fork is not working due the angle that is tuned to...

Cut the XT60 and solder the MT60 at the end of the cable. If you don't have a cable make one with a xt60 plug on one end and a MT60 on...

It's not just the weight, it's also: - Uses mostly bicycle parts for the drivetrain; dramatically more mounting/alignment/improvement...

The manual format does not make any sense, there is no way you can print it properly as booklet or any format. They should redo it in...

Yes, you can use the rear chain guide, it was in the kit. I'll put it on today with the 34t front chainring.

What do you think of the noise? Now I am sure it is making it all the motor alone. The chain was pretty quiet this time, and probably...

I found the quietest place around here and this is the noise it makes, climbing at 12-14 km/h on a steep hill. I have put only 20 km on...

I'll have to test it properly. In a few days I should be back where I have the bikes and will take a short video of it working. Honestly...

What would be telling about the maximum voltage is opening it up and inspecting the caps and FETs on the controller. 15s at 100% state...

I have tested mine with a temporary battery. It works. Torque sensor calibration procedure is simple, but could be more clearly...

This is the first/old revision: it contains a few errors. BB instructions is no good and there is no Isis BB at all. Mounting plate...

I'll assure you I never had this problem with any of my bikes, I am 45 and I had my first mtb probably in the late 80s when I was 11/12...

I think the lightest was designed with "normal" mountain biking stuff in mind at EU legal power levels, with some more spice with the...

They now sell an integrated chain guide mounted close to the pinion gear, and you still can adjust it. I hope it's enough. I just...

The motor itself looks pretty refined, very compact and light and quite powerful for the size (judging from what other say, I haven't...