Recent content by Jonni

The mould was created using a 50% sand 50% plaster mix. The sand makes the mould withstand the extreme heat better than a 100% plaster mould. Check out https://www.youtube.com/watch?v=0bxOzCgUj_U great video for more details: https://www.youtube.com/watch?v=WWVVSZP3Au4 I would definitely be...

That was my original plan as well: to cast the whole hangers with the motor mounts built in. I ended up doing the separate plates for few reasons: it was easier to model the plates than whole hangers plates were easier to print than hangers not sure where I could find strong enough threaded...

I made my furnace following along this build log: http://3dtopo.com/furnaceBuildLog/ It's a steel barrel layered with ceramic fiber blanket and fire proof cement. I used cardboard pipes to cast the cement in to the ceramic blanked layered barrel. Here's few more pictures of my furnace build...

Hello, just wanted to say hello to the Endless-sphere community and share my project with you guys! nt_1t7D4-9k I made the motor mounts using lost PLA aluminium casting. The motor mounts ended up really sturdy and fit really well in to the trucks. Highlights of the current setup: 237Wh...