Recent content by lightrush

You can't. The square/trapezoid connector is for the newer CAN bus controllers and sensors. The older round HiGo connectors are analog voltage based.You need to buy the CAN bus version of the torque sensor. I know they aren't cheap. Condolences. 💀

The ERider_T9 setting uses 36 poles.

Nylon loses strength pretty quickly with temperature: So at 70C at the gears you have "half the strength" of the gear teeth than at 50C. At 90C there's almost nothing left. I don't know how the stator temperature correlates with the gears but I'd assume something like 20C delta. So when it...

Does something like this qualify? If yes, a G310 in the rear, a large 40T+ cassette, 2-3 LiGos or equivalent small battery in a frame or saddle bag and you're good. Since the Baserunner controllers don't have built-in PAS yet, you could employ a Cycle Analyst to do it and hide it in the bag as...

Also limit the power to 400-500W.

Yes if it's all assembly, you're probably right. C is as low as one could go that allows for decent collaboration while providing damage control. 🤣

@justin, think about whether open sourcing the existing or a future codebase for a new platform might be a net benefit for you. Even if that's under a restrictive license that gives you copyright over all source contributions, giving you the ability to re-license the complete codebase at any...

Really nice idea! I've independently almost resorted to doing exactly that - getting an Arduino or a small Pi to convert signal from a peripheral to force the CA to do something I wanted. But yes, finally **that particular one** is no longer needed. I've also had another much more blasphemous...

Just tried the 3.2b2 today with my Erider-based PAS setup and I have to say - after so many years we finally instant torque from standstill! I first used a CA to control my system in 2016 coupled with a Thun BB. New torque sensing BBs like the Sempu T2, then T4 improved responsiveness. So did...

Erider T9 with 36 poles? Please elaborate. I acquired a 36-pole T13 from AliExpress which I haven't tried yet. Is this new T9 the same as the current T9 but with more poles? Is it actually "T13", different, when can I buy it?

Sorry to hear that, but the decision to open source this is a great one. I'm currently running an Erider with a CA and a G310 hub. The Erider seems to coexist fine with the CA. I think to be useful we'd need the freewheel hardware for the Erider so we could mount it. Then we could tinker with...

Same boat, I'd like to know as well!

Paul, my dude, my G310 is beginning to exhibit some unhealthy noise. I need your help! (by letting me buy one of your kits)

Paul, can't you put a strain gauge of some sort on the pulley to detect torque from the crackset?

Hey Paul, the new kit already shows as sold out on the web site. Is there a chance to get a kit anytime?