Recent content by Localhorst666

  1. L

    TSDZ2 mid drive with 860C, 850C or SW102 displays only -- Flexible OpenSource firmware (Casainho code only)

    A minor issue: this (see attachment) happens sometimes when I change graph by using "-" / down. I read somewhere that another guy experienced the same.
  2. L

    TSDZ2 mid drive with 860C, 850C or SW102 displays only -- Flexible OpenSource firmware (Casainho code only)

    That would be a possible solution for my "light Problem" as well... Use a step down and not switching lights by software. [emoji1787] @casainho I just checked assistance regarding lights. My problem is caused by the lights! If they are switched on, the assist goes off. As soon as I turn them...
  3. L

    TSDZ2 mid drive with 860C, 850C or SW102 displays only -- Flexible OpenSource firmware (Casainho code only)

    Hi, it is saved I think. I disconnected battery for 2 days at the weekend and the value is still the same like on Friday. But I have an issue with the clock. Maybe odometer will be saved if you turn off by using remote switch only!?
  4. L

    TSDZ2 mid drive with 860C, 850C or SW102 displays only -- Flexible OpenSource firmware (Casainho code only)

    OK, I just read this issue #65 on GitHub. When I checked speed sensor yesterday, it seems to be working without light. I was able to start motor assistance three or four times, but I did not do a real test drive. So, I think you are right! Should I measure the battery current just of my...
  5. L

    TSDZ2 mid drive with 860C, 850C or SW102 displays only -- Flexible OpenSource firmware (Casainho code only)

    Yes, I'm using lights! They are installed at Y-splitter of speed sensor. I guess, that will be the cause then. Is it an issue with newer releases only? Could I help you to solve this issue somehow?
  6. L

    TSDZ2 mid drive with 860C, 850C or SW102 displays only -- Flexible OpenSource firmware (Casainho code only)

    Hi casainho, Set speed limit to 50 km/h has no positive effect. The hall sensor is working well. Speed is displayed properly and magnet is in line with speed sensor. Speed sensor was working for older versions together with VLCD5, too. It works as it should be directly after turning on only...
  7. L

    TSDZ2 mid drive with 860C, 850C or SW102 displays only -- Flexible OpenSource firmware (Casainho code only)

    Hi, I tested 850C_v0.6.2 since last weekend and switched yesterday to 850C_v0.6.4, in each case with related motor firmware certainly. I have a very strange issue. Even after the torque sensor calibration. Sporadically there is no motor support even on high assistance levels, sometimes...
  8. L

    Bafang 850C color LCD, currently working for TSDZ2 motor -- Flexible OpenSource firmware

    Hi Michael, As far as I know it's not implemented yet. See the line above "Key combinations": Note that the street mode is not implemented yet. https://github.com/OpenSource-EBike-firmware/TSDZ2_wiki/wiki/Features-and-configurations-on-display BR, Horst
Back
Top