I don't think there should be a gap between thr magnets and its binding. Not sure if this is repairable. I can't seem to find anywhere that will sell just the outer rim. This really sucks because qs 205 motors are like 500$
I believe my outer casing is warped. There is a visible gap between the magnets. Anyone know how or where to get a replacement without the motor? Its a QS205 v3.
It initially died on me and I found a chaffed wire coming out of the axel. The wire went to the 2nd set of hall sensors on the 2nd connector from my qs205 motor. I repaired the wire and the hall sensor it went to because it was showing dead(no lights on my tester). I am still getting an error on...
Well I am still getting a hall sensor error after replacing the dead hall. The motor doesnt turn over easily which I've found other fourms saying the phase wires are touching but I get continuity between all phase wires. Not sure where to go from here. Qs205 motor w/ sabvoton and risun controller.
This was the key. I thought that the other hall sensors were for the back up plug but it seems that all 6 hall sensors are needed and one of the sensor is dead. It's on the wire that was cut and I repaired. Now to find which hall sensor to order for this QS205
Thanks for the replies. I actually jumped the wire and got the display to turn on but then a hall error popped up. I have a post on reddit(https://www.reddit.com/r/hyperebikes/s/8Q2rUADxl7) talking about all the things I did to get it to work. To get to the point, I cracked open the hub because...
Do I need all the other cables hooked up to power on the display? I'm trouble shooting my ebike(previous controller(Sabvoton) is displaying 30h and can't figure it out. Can't connect either to the app). When I hooked up the power cable, there was a spark. Im guessing that's the voltage loading...