Recent content by Mlubbock

Hi Folks, Same for me too - I downloaded the google drive shared folders (thank you Josephm) but the MQCON-current unlock.exe is not there. I assume it's been deleted(?) I'm looking to unlock my 72100 to 72150-ish if at all possible? Cheers, Myles Stealth Bomber 15kW rear hub with 2.4kW/hr...

Now you come to mention it. My brand new SVMC72100 doesn’t have the white temperature wire in the motor multi plug. According to the MQCON wiring diagram it should (that’s potentially a problem for me). Perhaps the temperature control is now only monitored within the controller (?)

Cg, I think there’s some potential to tune the motor temperature and current limits. I think, Unwork should be top temp - perhaps 100C (Stops) Rework gives you the hysteresis- perhaps 70C (restarts) Limit current perhaps 60C (reduces current) ??? You could try disabling the motor temp sensor...

Cg, Correct me if I’m wrong but I think the Sabvoton is looking for a throttle voltage signal from a potentiometer not a series of blips from a hall sensor??? At max resistance you’ll have close to zero volts and at min resistance you’ll have close to 5 volts? That seems to be confirmed by your...

Hi CG, It seems the root cause lies with your different throttles(?) If so, firstly, would it be worth or possible for you to measure the resistance between the wiper and pot low and at pot high and make the comparison to see if the resistances are similar? Secondly, given your settings for the...