Recent content by Monti

Thanks for that. Makes sense

Thanks Lubon. Sorry I missed your reply When I connect them- on the board there are clear holes where to connect for the b- and c- but the p- doesn’t seem to have any holes Do I just connect directly to the board anywhere in that p- section?

Hi I just received a new bms and am not sure how to connect it. Specifically the b+ looks like there are numerous connection points do I just chose 1 B- seems clear- 2 holes bottom left corner Then for the charger and load I presume I connect to the two holes on the c- side bottom right Nb...

Thanks for all the answers. I managed to charge them all up using a single cell charger. then I discharged them all using a light bulb to get the total down fro 60v to about 57. This meant I could set it all up to use (even if the bms did look pretty bad). Took it for a ride and it cut out...

Hi All I need to change my bms but want it to be a seamless change so need the balance connector to be the same and ideally the whole board Its 60x80mm and the balance connector is about 35 mm. Photos attached Any idea where I can get the same or a compatible one. It is in my 52v shark pack...

Hi I have 52v shark battery. The case broke and it got wet inside and then the bike would shut down after a few minutes of load. I took it all apart and found 2 blocks of 5 cells that were showing 3volts the others all showed 4.3 or 4.4 So I have changed the cells but when I charge it up the...