I currently have an SW102 display within an existing system and was hoping there was a way to get it functioning with a new KT controller upgrade that I recently purchased. Is this something that is possible given the open firmware available?
Thanks so much for the additional information here and within the ebike subreddit NCC1941.
Are you aware of any other controllers that would allow a more minimal installation while still offering FOC and torque sensor based pedal assist?
Is it possible to run a pedal assist only configuration utilizing the Sempu BB without the CA? I am wanting a very discreet setup because of theft concerns and given the use of the bike would not have much need for active monitoring after initial setup in the Grin controller software.
If this...