Recent content by Peter Built IT

First I can't thank you enough advising me. Electronics is absolutely my weakest discipline. So thx. Im hooking up a new Bafang hub motor to a new controller with matching display. Trying to keep old brake,throtle etc... Both controller and display are Kunteng and recommended by AGS. My old...

I'm back from vacation (Holiday) And thanks to the guy behind me on the plane hacking up a lung I got covid. I'm so glad it didn't hit me until I got home. But this hopefully gives me time to workout the bike wiring this week. In Paris I saw how bikes are the #1 way to get around. Everyone ride...

On the motor I needed an extension cable to reach new controllers home. I found this one that matched the plug on the motor but the wire colors seem odd. One is light grey and another is bare wired. Does that seem odd to you? the motor extension cord is made by CUSMADE.

That's good news, I hope. I received this from the bafang retailer I bought the motor from. I don't know what all this is but perhaps you do. These are their perimeters for KT controller and display.

I received the 5 way block so I wired up the big wires. I'm presuming the wire colors are matched up , no swapping around. Is that correct? I'll be back in touch in 3-4 weeks after Holiday.

Thanks for describing. I'm understanding the process better. I'll start on it when I get back from Vacation. The last parts should be here then. Thx

This is what I was looking for. I guess I can check conductivity on the cord with a slim needle and the multimeter but its matching up the colored wires coming out of the controller. How do you have it connected up on your bike? Do you have your handlebar devices with plugs that match what the...

That's exactly what I have but if it's 1-2 ft longer it will reach the controllers new home. As is it just might work but will be tight/ limiting when connecting the wires to the controller. How will the controller wires connect to this cord? Cut and splice? any diagrams exist on correctly...

Let's talk about the 9 pin/ 5 way cable My bike is using and I hope to keep using. Ive been looking at the new controller/display and thinking how I can keep my 5 way cable. I'm thinking of clipping the lead off the old controller and using the plug with exposed wires to hook up to. Or since I...

Ok I have the new controller & display. Not all the extension cords yet to get the wires to new location. So i'm not ready to start. What is the process like getting it all wired up correctly? I'm presuming it isn't as easy as connecting like colored wires. Or is it? Also I received a email...

Cooler King would have been a great choice for what I was going for. A lower seat looks better. that frame is available here but it's delivered with a wood textured tank. Also they're sold for $1000 more than mine cost without any other improvements. My bike sold pretty cheap when paying cash...

I ordered it. Free shipping from UK. Under 8 bucks total cost. If I mailed it the other way from US it should cost $15 just for postage. I'm guessing you are in the UK?

Thanks again. I found a container to put the controller in. it's a vintage 1950's tackle box. its got nice round contours. Bigger than needed but once I remove the handle and latches it will add to the looks and fill the void like your bikes box. If I don't post for a bit Im just waiting for...

I was able to use the password but the magnet poles was not shown. I'm going to order the controller you listed with a new display that mounts the same as I have. Thanks for the lead on what to get. the controller won't fit in the same spot as the original controller but moving it will be...

Thanks, I'll try this tomorrow, I work today. The braking chain is definitely in part the alignment. Jumping teeth is a regular occurrence. That's when the chain brakes and mostly at the "quick links". When I went to a heavier duty Cargo bike chain it got a lot worse. I'm thinking the ability...