Recent content by pishta

As stated the throttle only reports back to controller 0-4.8/5V depending on where the throttle is twisted. If you have more than 5V in, I bet you tapped into the 12V display rail or battery 48V feed to the battery meter on the throttle. Throttle and brake should be 3 wire red/green/white or...

My controller has a lcd display that has "P settings" that allow you to set the undervoltage parameter, or battery cut off voltage. My 48v Fluid Freeride Horizon scooter has this throttle and it's set to cut the motor at 42v . I have come across 3 BMS issues on 4 scooters (low output voltage...

Wait, I had the same thing happen to me! I had a xiomie type 36V 10S3P pack but it had a BMS board soldered to the top of the entire pack with its pick up points folded onto by the nickle strips and/or jumper wires going up the sides to the boards contacts. I was getting 41V at the B- and B10+...