Recent content by Pwnlord187

Ok I will see what I can do, starting with the .apk

Awesome work!! Hey, is there any way the BluOSec app can be switched to a landscape layout rather than portrait? Thanks for everything

Im not sure what the controller cuts out at, or if it even does. If youre concerned about it I'd say just add a second bms and just wire it for discharge protection, or get another charger

Yea.. while upgrading the haibike I've basically found that it was a domino effect of replacing every single thing that is yamaha on the entire bike. The better route would be to leave it stock, tune it, polish it, charge it, sell it. And instead build an ebike by installing components or a kit...

Hello peeps, I have a few questions regarding how bms's work and if these wiring scenarios care possible, and I hope someone is able to answer.. I have 2x small cheap 10S bms's and I was hoping to daisy chain them together and use on one of my 14s packs. I was thinking of running them both as...

I'm not sure I fully get how you wire these? Just balance leads only but where would I connect the BO or negatives? Pair them up and connect to my main - wire, or splice in somewhere else? Thanks Also I'm already bypassing the discharge on my bms's, what would be any drawbacks to bypassing the...

I've done it, seems to work pretty well on the Haibike sduro. Once I removed the controller I had to bypass the discharge port on the bms for it to run. The wiring configuration for the 1500W KT controller is to swap the Y and G phases, and with the Grinfineon 35A controller, either swap the G...

Nobody? :(

(the cells will still get balanced when charging, and still be protected from low voltage damage from the controllers operating range)

If you bypass the discharge on your Yamaha battery pcb (cut the thick red/black wires going to the board from the discharge port, and solder them to the main leads of the pack, which are oval shaped solder pads on each end, the one closest to the port is positive) if you do this you won't be...

Considering a ca3 to process and configured the torque sensor if possible

Any luck with this? I'm doing the exact same thing

I have the Yamaha motor bypassing the internal controller and out to my external one, everything seems fine except I don't have pas. Was looking into different add-ons available, and when I look into torque sensors the price can be pretty high. This motor already has one but I can't figure out...

If the growling you speak of feels like your whole frame is rumbling and buzzing each time you open the throttle in my experience its been an issue with the blades of the anderson phase plugs not maintaining a locked connection but instead having the blades touch but rattle on top of each other...

Static balancing balances while your battery is idle. Shifting voltages from one cell to another. In this mode my first cell temporarily goes lower than the rest but normal when completed or when I turn the balancing off (I just set my balance start voltage high to turn it on/off) I'm assuming...