Happy to see this feedback!!
So nice the level that this project achieved. Everyone helping a bit, I think it is natural to be passionate with ebikes and return the joy by helping next ones.
Thank You Casainho, Buba, eyebicycle and all who contributed and are contributing to the project...
I received my bootloader and 850C today. Opening the box took longer than updating the firmware. Just follow the posted instructions. BOOM. DONE.
Great widget that is worth every dollar. :bigthumb:
I have the same problem -- different green wire. How did you get the two wire bundles to push through? I've got the water-proofing peeled back, do I cut through around them -- or just push really hard?
Thanks.
Are any more torque sensor readings of any value?
I was experimenting with the sensor measurements yesterday. The bike read 38 resting, but after a short ride it read 36 (resting). The max reading with me putting all weight (99.5 kilo) was 72 (on relatively flat ground). Firmware 18.2 on LCD...
I've downloaded the proper software and files and exposed the programming pads. The pads are quite a bit narrower than the LCD-3 connectors. Are you soldering pins to the pads or just bending programming pins from the st link five wire into a narrower width? I was thinking to cut the corner...