Has anybody put a TSDZ2 on a Cannondale Trail 7 with 29" wheels? I just picked up a good deal on a 2020 model and I want to swap my TSDZ2 from my old bike. Any thoughts or suggestions?
I have read on other posts that the voltage reading comes from the motor control board. The controller maybe your problem... not sure if settings are stored in the display unit or motor controller. But, since the firmware uses the settings for all of the calculations to operate the controller...
After making a change to a setting you have to hit the menu button again to remove the red line from the value just entered. This sets the value and then you can go on to the next item by pressing the up/down button.
I received the new unit and I installed it. Seems to work.... haven't ridden...
I am going from memory so my wording may not be exact, but under settings>assist level>power level> level1> lowered it 5 points (I think). I agree about the firmware being a HUGE improvement from the stock.
I hope you can help solve this. I should receive my replacement 860c today!
I have been using this OSF version for about 2 months without an issue, mostly in hybrid mode. It has been working great. I can get about 70 to 80 miles with an average speed of 14-15 mph on a charge from a 48v 13ah battery.
The problem came up on my last ride. I ride mostly with assist level 1...