Recent content by spudman

Calab who has said people don't have lives, I know that, what makes you think wolf was holding my hand, if I knew about electric mopeds, I wont have came here would I think about it. As this is a forum to help people. has amberwolf spoke or messaged you regarding him helping me, as I cant...

What you on about. What’s this a pay for help forum then now news to me. As had no bill sent pmsl He must be having time out. Not a problem just wondering where he was but it’s ok

its no good if he isn't here, as he was helping me loads but not heard from him no more in about 4 days I think

has anyone seen amberwolf lately please as he has been helping me on my electric moped. as not seen him for a few days apologies to have to post here but I didn't know where else to ask

I dont know where you mean when you say Where is RC places I dont understand that bit. who makes that panel mount holder where did you post that Yes I found that controller very expensive too, but its suppose to be for the Erider Model 15 Yes I will try to make up a diagram of bike wiring...

Hi again amberwolf I must admit I was getting a bit worried as didnt think you was coming back, but silly me dont realise we are not always online, have other jobs to do as well anyway, I have been a bit silly by jumping ahead, I will of course now replace wheel and do those hall tests again...

Hi again amberwolf I do hope you realise all this help from you is most appreciated as I wont be able to sort moped without your help its the FET test btw do I also remove the 5 hall sensor wires from controller when Im doing the Phase wires test FETs ok I have taken images of my 2 meters...

Well I touched the black probe on that wire then tried the green phase wire 1st. And all phase wires wasn’t connected to controller and I put meter on continuity and nothing happened but I thought continuity was to see if there was a break in a wire so are the green and that black wire supposed...

Hi again amberwolf just like to say again many thanks for helping me, its most appreciated, But Im afraid Im still clueless about where to touch multimeter black probe for ground would this black wire in yellow square which goes to the controller be ground wire as the opposite one in the blue...

Hi again amberwolf, I will be going to collect this new controller today from Royal Mail, as I was out when it came. But I will test old controller 1st. now those connectors I posted these below are just some connectors I use to test things nothing to do with moped you just press down the top...

Hi again amberwolf I cant thank you enough for all your help its most appreciated, hope you had a nice xmas and a happy new year to you. Ive had my moped in my flat now over 2 months and I live in a 2 story flat Im on 1st floor, so 2 flights of stairs, so my brother helped me to take it up from...

When you say was the motor connected but isn’t the motor always connected. In the back wheel I’m a bit confused with that question When you say FETS do you mean MOSFETS How do you mean with the motor not connected to the controller the motor is in the back wheel isn’t it and I have not...

Hi again amberwolf Yes its 10.0ohms not v Yes as I have not looked inside back wheel Well I contacted Erider and said the controller says 350W and 25A on it and they said yes its the right one, But then just because its right one maybe not same as Eriders Original I dont know until new...

Hi amberwolf thanks for your help this is what someone on another bike forum told me to do, as its only a bike forum they suggested to go to this forum as its for mopeds etc this is the controller I have atm Also I dont think I have explained things right. at the back wheel there is 2...

Hi amberwolf, I have done all the wiring tests with a multimeter, Dc voltage, Ohms, and continuity too. I have had to go ahead and order a new Controller from Erider for the model 15 as I cant see why it wont run no more. it did have a dodgy grip throttle which I removed. I have never seen so...