Recent content by Teddy105

DC to DC converter 3 prong plug. Take red power wire and tap into power battery cable or hook it directly above or below power cable lug on the controller. Follow same steps but with the black ground wire to ground cable.. etc. Then take yellow wire tap into the ignition wire I believe...

I removed park input as well as changed it to pc15 and it did not fix :( any other possible solutions?

Ok will try this. I just plugged in my spare throttle tested it to and it runs fine throttle but once plugged in. Still shows hall fault. I also retested the motor hall and motor winding and it is all showing no damage and running okay... so hopefully it's just this then?

Hello I've recently purchased an Em150s My hall wires are reading out to be 120⁰ No damage either Phase wires seem to be okay to My throttle also shows it is in working condition via ebike tester For a short period of time I was able to spin up hubmotor with throttle, now I am unable to...

Hello, does anyone have the newest version of the Votol em v3 program? I currently run a em100s with a QS 17inch 273 5000w hub Im achieving just over 105-106kmph on flat ground and up to 110kmph on hills (using gps) I am content with this. However has anyone figured out how to properly use...