Recent content by Trawleysteve

I wrote to E.Lyen regarding the switch settings, which I have not altered in the controller and this is his reply: I generally program the three-speed switch settings as 33%, 66%, and 100% to have them spread evenly. As for the no switch input default to 100% and position three at 120%, it is...

I think because I have disconnected it from both the Lyen controller and the CA and my top speed has dropped by 10 mph. There is an influence from the Lyen controller and maybe two of the wires on the Lyen controller should be connected together to give full speed? And then I can control it with...

I would not say the throttle doesn't have a dead zone any more. I have tuned it all out and the test ride went well today. A huge improvement. I would say it is now respondinging like a motorbike throttle with a tiny amount of movement before the power comes on. Yes fixed completely as far as...

Trawleysteve wrote: ↑ Jul 09 2020 3:19pm (DID THIS TEST AND REQUIRED 1.43V (17% OUTPUT)JUST BEFORE THE WHEEL STARTED TO MOVE. NO REDUCTION IN DEAD ZONE) Then you'd use 1.43v on the Throttle out minimum. That will translate the lower throttle in voltage to this, inside the CA. (CHECKED THIS...

Suggestions for settings to use are below. If this is already how they're set, leave them at that. Trawleysteve wrote: ↑Jul 08 2020 6:37pm Input Power Mode; Power Change this to "pass thru", so that power response limiting doesnt' come into play, to make it less confusing, but so that voltage...

Thank you again for your reply amberwolf. I tried to screen print my setting but no joy. So here they are long hand; THROTTLE IN SETTINGS Input Power Mode; Power Zero Throttle Threshold; 0.86v Full Throttle Threshold; 4.26v Fault Throttle Threshold; 4.5v Throttle Auto Cruise; Off Cruise Hold...

amberwolf. Thank you for your concise reply. I have answered most of your questions and point in brackets You don't mention which throttle you're using. (Wuxing 20X as sold by Grin) Many of them physically don't provide any change in output from the minimum 0.8ish volts they *always* output...

I am running at 72v 65A, with a MXUS 3Kw hub motor and an 18 FET Lyen 18 FET 4110 Mark II controller. All control is via the CA3 which has the latest firmware installed. However I cannot get the throttle to start giving an output until I have turned it approximately 25% round. Also at the top...

Yes CNX 54. The problem is I am in the UK. Do you know a brand name/ type of these so that I can buy them in the UK?

Can anyone tell me the make and type and model number of the white 2 pin and 4 pin connectors for throttle and halls etc on my Lyen controller. I have been told they are Molex but cant find the correct ones! Thanks

Thanks for that info.

Have recently burnt out my HT3540. My fault really, too much current at 72v!! I wondered what the best option was. Have it rewound buy a new stator,( if available) or replace with something more powerful. I am using it off road in the hills. I would like a motor that would directly replace the...

Thanks for the reply's, Stripped the hub down today. Windings are burnt out. Any thoughts on the most cost effective option; have it re-wound, new stator if available or an alternative motor. I am mainly using it off road in the hills. Thanks,