Kudos,
According the spec I think the frame support 135-155 dropout. Do you have the torque plate installed on the inside of the frame to get the dropout at 135?
subscribed!
Looking forward to your build. I've been thinking about this frame too since seeing Roadrash build. My only concern is standover height for the frame. I'm fairly short guy. Waiting to see what Paul comes up with battery and as a packaged system too.
Chunder123,
Thanks for getting the info on the headset. It looks like can reuse 1.5" straight tube fork from another bike :). I'm a fairly short guy at 5'5". Can you take minimiun standover height and minimium seat height? I want see if i can fit the frame. Thanks!
Roadrash,
It's hard to tell from the picture, but I would like to know if the headset is 1.5" straight tube or 1 1/8 - 1.5" tapered headset. It comes with adapter to fit 1 1/8 straight steer tube or taper steer tube, right? Thanks.
Jonas,
Sorry to go off topic. From your picture I see that you have A2Z disc brake adapter with disc break on Matt's sprocket adapter. Do you have disc brakes working? I have an old Specailized bike also and would like to put disc brakes using A2Z adapter. thanks.
Looking forward to your build. I've been looking at the basman frame myself. Do you know what size the rear is? If it's 170mm I can reuse the wheelset of my fat bike. I hope the frame can 26x4 tires
hey myzter,
nice freewheel cranks. can you tell me what ISIS bottom bracket you are using, what length? I just got some ISIS Echo trail cranks. I'm looking for a extra long ISIS bottom bracket.
thanks
For those that purchased Hyperion with 1420i ttpack lvc board kit. Does any know if I can cut this board in half? I would like to cut it so I can put the batteries in the hammond case. I'm planning to do 12S2P. thanks.
Hi Ypedal,
I just purchased some four new lipo from HobbyKing. They are the Tunigy 6S 5000mah 20C batteries. I want to make sure that I don't screw up the batteries this time. Can you share your hyperion EOS1420i charger configuration set up? I'm using a Meanwell 24V power supply. I know...
can't wait to see it how you handle the chain slack with drive. I still have your sprocket adapter :). i was planning to do my new bike with freewheel cranks on the right side. I might have to wait how you build it out now.
subscribed! can't wait to see how you plan to put your rc drive setup. will your new crank setup be used? I'm keeping an eye real close to this. I just got a new full suspension bike coming and I still have your v3 drive to put on it.