Recent content by wayfarer_boy

Yes, I can see it's a slightly different configuration to mine. Had I not just successfully flashed my new motor, I'd be inclined to order in yet another STLINK! Flashing the new motor resulted in zero errors, successful first time, so I'm now sure I've done something irreparable to my old motor...

That's given me a bit of hope! Here's the lead I'm using, along with one of the STLINK-V2s (I bought 2 just in case the first was faulty). and closeups: I read on one of the posts in the TSDZ2 firmware thread that removing the housing for the STLINK-V2 may help reduce the possibility of...

Since my last post I've ordered a new motor. I figured I can at least start with a fresh slate and keep the other motor for parts or perhaps replace the bricked controller later on down the line. I'd done almost everything you mentioned in your last post (which was extremely helpful...

I followed these instructions, so everything's definitely installed correctly and in the correct location in Windows. I've done the same in Linux via these instructions. I've also made sure any other apps are closed before starting the configurator or stvp. I've devoted this weekend to...

Hi all 3 weeks ago I installed my new TSDZ2 kit and experienced an issue where the motor would cut out once I reached a high cadence. Reading that flashing the OSF (the emmebrusa firmware as I'm using the stock display) might solve this issue, I set off ordering my STLinkV2 and installing the...