Recent content by weldinpatt

Instant gasket is an excellent alternative, a bead in the groove let it set slightly then fit it. It worked for me. However the Tsdz2 is made from soft metals so use well fitting tools. I stripped a thread because it was in past it’s limit when assembled in the factory. Put the outer cover on...

I’ve purchased a few motors with weld in only. I like the idea but but I like steel frames and therefore don’t fancy welding that aluminium motor hanger into an aluminium framed bike. I would like to see steel motor hangers, Welding none butted tube with thin aluminium walls ain’t such a good...

Yes I am new to this subject. 1Boris, yes 120Nm sounds a lot. 36 x 14 = 504, is this what you mean? I have the 500W version according to my Dpc18, it peeks at about 900W. They say as much as 145Nm, I don’t know. What I do know is connected to an X-RD3 I climb all Snowdonia hills and still...

Look inside and the picb is printed with the gnd-, live, 5V, Tx & Rx. It’s when a Uart, system is crossed with a Can-bus display. No no, I think they each have their own 1T4 cables too.

No you’re in error. My M05 has been and is absolutely fantastic 500W. I since received a new BBSHD, and my word am I disappointed with the 1000W Bafang. I’ve coupled the Truckrun, to an X-RD3. And I believe it’s the personification of, the most ideal ‘e bike’ motor I’ve tried. The M05 is so...

Don’t look at centralised to the detriment of chainline. I got a 68mm when I measure the centre to the BBSHD, 42T chainring gives me a chainline of 47.5mm, absolutely Bob on. It matches within a mm the rear sprocket on my IGH. I don’t know for sure if the motor is central I just pushed it in...

Hi, Bosch/Nuvinci Harmony, paired, all motor info and gear ratio adjustment firmware combine to change drive ratio as gradient / headwind alters how hard pedals are pushed and it gears up or down in accordance. So to get your desired effect gearing would need to be considered and dealt with...

I ride a trek equipped with a bosch cx / N380SE. while researching the Nuvinci i read an opinion that suggested it was most suitable to the rider with more mechanical understanding. tsdz2 retrofit kit, I suggest is too. Age 60, a trained engineer, I see many trainees, nice lads interested in...