Recent content by wer2000

I've seen a couple of videos of people reusing LG Chem modules such as...

I've been looking into these cells a bit more lately and I'm trying to come up with the best way to run two of these modules in parallel with a BMS installed. I've worked with smaller 18650 packs before but the process for wiring the BMS is nothing like this and haven't found any good...

That's what I figured, thanks a lot.

I think I'm right here but I would just like to double check something for my planned battery build (48volt, 8p13s, 18650 pack with a max discharge of 20A) Aiming to use 0.15mm nickel strip to make the connections between the cells. Obviously the series connections will need to have multiple...

Not sure why I did not think about that but yea the idea of using four wires instead of eight is a whole lot better. Since it is easier to go the wire jumper route, and it should be almost the same as the copper crossover, I think I am eventually going to go that route. As for the wires...

Ok so I've been looking at building a new battery pack for a long time now and I really want to make an 8p13s 20amp discharge pack for my ebike. The only problem is I'm having a tough time coming up with a good cell layout for the space that I have. I have watched a lot of triangle pack videos...