Recent content by Wizzo

Will do best bet, as don't understand how it has so many saftey features from blowing it up, but seems that's only thing that has happened, will let you know what I find. Thanks What do you mean by potted inside?

I don't see what you mean by 1 of 60 thousand, if your being arrogant and smart, Then be smart to help me!! An the followers thing. Wtf is that supposed to mean?

The person above you seems to of understood everything, as assume he has been following my every post properly to understand!!!

Thats exactly what im thinking happened must of happened when trying to measure the voltage. But the amount protection cut off voltages etc for scenarios like this from reading the sabvoton 72150 specs sheet

The bike was bought already made the 12v are as thin as a hair and has been operational till I wanted too test the volts to splice into them for my gps, that was the whole plan

I have power from battery but no light even on controller now. The spark was to big for such little gauge wire for the 12v alarm power

I have disconnected, started from scratch, battery is reading voltage so power going into controller but nothing

That was my settings on multimeter

Hi i hope someone can help, I was testing the 12v to alarm system via the connector an was going to spline into that for my GPS i just bought, as doing so i may shorted the alarm 12v, but for them low gauge wire, cant understand why the spark was way bigger than the current, Ive tried unwiring...

What power motors tho?

I'm in need of buying 3 hall sensors to replace in my hub. But don't understand the voltages etc.I know 5volts go into them but ones I'm looking up go in different voltages and. I have a 3000watt hub that can peak at 8000watts. Just would like to know wich powered ones I need? Its a Chinese...

I'm testing other resisters on another old bit of circuits I have and all giving me readings, but each setting reads different amount what ohm setting would I need to find the right 1 for it? Feels like I'm getting somewhere now. Thank you all

What I've replied first is what your saying then. Thank you for explaining it better to me. How do I know what voltage resister needed tho if your saying between them voltages?

The multimeter reads 1. Then touching the probes together goes to 0.00 untouch probes an goes back to 1. So I've unsoldered the resister from board and stays at 1. What ever setting I put it on?