Recent content by XSRe

I wanted to confirm if you can program any (programmed or unprogrammed) ASI BAC controller with this software and without a login? Because from my limited understanding so far, it seems you need a login to program the controller? Some clarity would be much appreciated. Regards,

Out of interest, these where my settings before I blew the controller MOSFETS with QS138 V3 reduction geared motor.

Hi, My EM150 has blown 8 MOSFETs running at 55A for 1 week then 75A for one day. My motor was locked/difficult to turn. I check the resistance between the phase connections and the U and V phase have dead shorted. I opened up the controller and found a dead short between 8 MOSFETS on the...

@kibe019 Did you have any luck fixing this or finding the root cause? I suspect it maybe a blown MOSFET that's shorting a pair or more of the phase wires. I'll take mine apart and investigate as I'm now having the same problem, after a week of the controller working fine.

Hi @scoder, Did you manage to find the fault of the 'overcurrent'? Was it the controller or motor? Any help or pointers from people on how to test the motor and controller in this situation to be able to diagnose the fault. Previously it has been mentioned that a MOSFET may have shorted...

This sounds interesting. So if I understand correctly the ‘hall phase angle’ is simply the angle between the sensors. And the ‘hall shift angle’ is this the angle between the sensor centreline and the magnet/pole centreline? 🧐🤔 one more question, how does it become impossible to diagnose a hall...

Hi folks, My first post and apologies if it’s to take and ask for information, but I hope I can contribute once I have my setup working. I have a EM150 (non SP) and I was wondering if anyone has got the this motor working with this controller. If so, what settings have you used. In particular...