Recent content by Xtr6

Dutch regestration as A1 ?

Its a nice bike but not road legal to get in EU.

send you a p.m.

Got the problem solved with the help of cowedlyduck. Thanks mate you saved my summer. :thumb:

It helped, a full reset and then a auto setup and the bike is running like before. You are my Hero. :wink:

When I do a autosetup the bike runs perfect and everthing is oke. But when the bike is with the rear wheel on the surface it starts hiking and is non drive. Who can help me this problems started out off nowhere, and I can't find a solution.

Got some problems with my gasgas eta. Did a new build so put the old F24 on the new build. Ordered a new 24F and waited one year. The new 24F arrived februari 2022, and build the new one on the old gasgas eta. Everything went well but since two weeks I have a problem with the combination...

Got a while running the bike with the 24F but at this moment I can't ride the bike. The auto setup goes well but when I try to ride the bike under load it 's just hiks and somtimes runs fine but then again it won't. Put in 3 new sets Hall sensors but notting seems to work. Without load te motor...

Solved the problem. The values in # Current change speed. acceleration, select of values from 50A/s to 50000A/s, in increments of 100A/s. braking, select of values from 50A/s to 50000A/s, in increments of 100A/s. shutdown, select of values from 50A/s to 50000A/s, in increments of 100A/s. After...

ss41 and ss41F work with a aditional pull-up resistor from 1 K ohm. At least with my 24F they work fine.

Need some help from the experts, got a new bike build with a new 24F same motor as my first build. The set up went not good because off bad Hall sensors but this is now fixed. My problem is that the bike is runnig, but the power responce is strange. On a flat surface it doesent come straith on...

I had for many years a roadlegal Quantya Evo on a moped licenceplate. After a batteryfire I change the battery and run the bike for a few years without any problems. It was one off the best e MX bikes in that time. But it was way to expensive. The bike is still running in the Netherlands...

Got the nucular working. Problem where the Hall sensors. I put new once but without the pull up resistor. Thought they made a update with the new 24F with a software possibility to ad it in the software. Did the 1 K Ohm restistors and the problem was fixed. Glad to have the bike running.

Got the throtlle and brake working but stil have a Hall sensor error. Put in a set of new ss41F hall sensors but stil have no signal in the nucular.

Got one off the last F24 and it was running fine on the new bike. Changed the motor and wanted to import a file but since then he doesn't do anything. In the display i run to the auto setup for throthle and brake and that went just fine but in the auto mode in the controller I got no throtle and...