Recent content by Ypedal

Finally found this : https://ebikes.ca/amfile/file/download/file/240/product/1495/ in case it helps anyone else down the road !

not 100% sure.. contacted Grin and let them know, could be the axle in my specific bike is oversize by some amount... not willing to remove it in order to check now that it's in there for the time being lol... Nobody on the PAS 6 into 5 eh ?

yes, exactly... i can order one.. but that will take weeks.... i can make my own, if someone can provide the pinout ! lol.. I have to go from 6 wires to a 5 pin connector... either one wire needs to be paired.. or omitted.. but not sure witch

Got mine a while back and finally getting it installed.. A few challenges, first was the rim option. could only get a thin 32 hole when i ordered it.. but was able to order a 650B wide profile rim.. so got a mullet going on with a GT Helion 9R... Axle was then difficult to get thru the...

I would 2nd all that and fully agree .. Merry Christmas everyone !!! I have been busy to the point of no longer being able to sit for hours on end in front of a computer screen as i could before while at a desk job.. For the last 8 years now ( holy somkes.. time flies by when life is good...

oh there was some experimenting .. :lol: Got it figured out, so to recap .. i have a 36v pack without any switches... Baserunner controller in the battery box wired directly to the pac + and - . From the BaseRunner, the CA wire is the new standard WP plug, the CA itself has the old style...

just tried this and no bueno.. Because the orange wire ends up on the V+ controller side the controller is always powered on.. Having a two switch system would work, one for the CA and another to bridge the white and yellow in the throttle cable, but i really want to make this a one switch...

Hey everyone. Messaged grin and asked via email then went looking and found this thread... ( should have done the reverse.. sorry.. i know ) So given the above scenario.. what if i cut both the V+ and Orange wires in the pigtail between the CA and the Baserunner WP plug, series solder my...

Giant Twist bike .. gutted and re-wired with an MXUS 15 amp 36v motor controller Bike / MXUS White = Yellow Brown = Green Grey = Blue for both Hall and Motor wires. NOTE : The Negative Hall Sensor Wire !!!!!! ... Giant used a network cable type cable with 6 strands + outer mesh inside a...

Cheers everyone !!!!.. eat, drink and be merry !!!.. woot

Fat bike - Fatbike - Motor Bafang G60 ( MG60 ) from ebikes.ca / grin .. and Grinfineon Controller C4825-GR 36-48V, 25A Sinewave Controller with ON/OFF switch, Proportional Regen, and CA3 Connector. For both Sensored and Sensorless Brushless Motors. ( leaving full desc for search reasons )...

Ok, this is an antique thread but ended up here googling for adjusting the pots / potentiometers on a High Power High-Power HP8204C charger ( writing it like that for future google search results.. f'n creative name for a brand but annoying as hell when searching for tech info instead of sales...

I quadruple checked it and yes, i'm positive i got it right.. This thing is pedal assist only ( no throttle ) and 250w so the 3 modes are pretty much meaningless.. put it all back together and the kit works fine with or without the display... reached the max time limit on how much i'll work on...

Hi guys ! Been busy lately and have not been around here much.. but the ebike home-shop is very much still going . Got an older model 2010 'ish .. Giant Twist , Lithium version, local bike shop no longer services or has parts for it.. it ended up here. Main issue is the display " Ride Control...