Recent content by Zak650

This sounds like the control is still in program mode and you need to go back in and set it to operational mode.

Hi Luke, Great thread and discussion. When you guys are programming the Gen4 are you using Sevcon's software or something else? Have you tried any disc type rear wheels to deal with all the torque you are generating? Zak

I too would like to be able to program a gen4 8035 to run the ME0913 PMAC Motor. I have two of the original single stack Mars pmac motors and would like to setup both running in a timed together parallel mode or with two controllers in a master/slave setup. Then get two ME0913 motors with two...

Hi, Does anyone have any experience with this controller from comcycle, $280 on ebay. Programming sources would be helpful. Thanks, Zak