Recent content by Zeuser

And according to Bionx's own documents (see link I previous post), they're MSRP $147 USD as well. PS: Dealer cost is $100... just in case you want to negotiate. ;)

And according to Bionx's own documents (see link I previous post), they're MSRP $147 USD as well. PS: Dealer cost is $100... just in case you want to negotiate. ;)

Nah, That won't work right. You'll get wrong numbers on the display and you really won't go any faster. The Best is to change menu #3773 and #3775, if you have a thumb throttle, and either disable the max speed or pump the numbers up a bit. Another recommended setting, if you have a thumb...

Nah, That won't work right. You'll get wrong numbers on the display and you really won't go any faster. The Best is to change menu #3773 and #3775, if you have a thumb throttle, and either disable the max speed or pump the numbers up a bit. Another recommended setting, if you have a thumb...

Do you REALLY want to know everything about Bionx? The best place to start is right here: http://bionx.ca/shared Get the documents and download them before they figure out their mistake. The procedure to enable the thumb throttle is there as well as other very useful documents. And the actual...

Do you REALLY want to know everything about Bionx? The best place to start is right here: http://bionx.ca/shared Get the documents and download them before they figure out their mistake. The procedure to enable the thumb throttle is there as well as other very useful documents. And the actual...

Not everything is here. In firmware rev 2.3 I noticed there's a 3774 menu. It shows PR and the regen logo. The only setting is on or off. I have no idea what this does. Something else I'd like to know which is not shown here. I did a code 5000 (full reset) on my PL350 and now the thumb...

Not everything is here. In firmware rev 2.3 I noticed there's a 3774 menu. It shows PR and the regen logo. The only setting is on or off. I have no idea what this does. Something else I'd like to know which is not shown here. I did a code 5000 (full reset) on my PL350 and now the thumb...