Recent content by Ziip0

Hello, I connected the bms, everything works fine, thank you again I haven't dared to charge the batteries yet, I want to be sure that everything is properly configured before, I don't want to ruin all these hours of work for nothing... I watched a video from Doctorbass which explains how to...

Got it! Everything's clear now sir! Thank you so much for your help! I've just ordered 120A Anderson connector instead of 50A that I have, terminals are bigger and will fit with 4 12AWG wires. I will keep the 8AWG B- piece for soldering blue wires, no reason to get hot, I just thought that the...

All right! Thanks for these detailed explanations :) What about the thin red wire? 20s positive according to the diagram? Or with + charger / motor phase? I will never have the space to attach the big B- connector to the first negative cell. I'm thinking of leaving a piece of the 8awg to...

Good good I begin to see brighter, thanks to you. - ok yes first I need to connect all the thin wires from 1s positive to last 20s positive. Also the thin red wire to 20s positive in my case? - then I have to test if the tensions between the wires are ok and show me the correct total packs...

Here's my packs if that can help, 1s to 20s right to left. So to begin I just need to connect black bms C- to negative controller and negative charger? I don't have to use blue bms B-?

Ok thanks to have edit your message, I get more infos. So the only difference compared to ANT diagram is the + charger which needs to connect to motor phase and not to the + battery? And for the little red wire, last positive cell like on the diagram or motor phase and + charger?

Yes ofc I know that, I just don't know how to correct wiring everything. To begin I need to connect blue wires B- from the BMS to the first cell negative according to ant bms diagram. But in my case with nucular controller with + charger on motor phase, it's also what I need to do? Then black...

Hi, I would first like to explain to you that I know very little about electric bikes. I bought a NYX bike a few years ago with an Adaptto controller installed on it, it also had an Adaptto BMS for battery protection. The controller broke down last year. I purchased a Nucular P24F to replace...

Hello, I would like to change my Adaptto Max-E 14kW controller (dead) for my NYX bike. I got a QS 205 3000W. I want same power, or even more, something that really kicks some *** Motor change is an option too. Any suggestions ? Thanks.

Hello, I'm looking for an Adaptto Max-E. Please pm me.

Hello, what is the best email to contact Adaptto now ? I need that they repair my max e. Cheers.

Hello everyone, I have a problem with my adaptto max e. I turned on ignition, the screen lighted up normally. Then the display dimmed to leave only the backlight. Sometimes the display returns but disappears again. Has anyone ever encountered this problem? If so, what to do to repair? Thank you.

Problem solved ! I flashed the screen and the controller with the firmware available on Adaptto's website and all is ok now :D :D :D :D :D Adaptto never answered me when it was almost 1 month ago that I sent them an email explaining the problem. On the one hand I thank them because it...

2 weeks ago it was like this all functionnal : Then I did modifications : I want to put the batteries but not before solve adaptto problem, please help me, I want to use my bike soon :)

I have something new. So as I told you the screen flashes after turning off / on again with the key and nothing to do except wait several hours before the screen can light up again but only once, do not works longer after switching off / on again. There I disconnected the connector with the +...