Search results

Date Relevance Most replies

  1. Sean9002

    Light dirt bike, QS 120 70h motor, custom steel frame

    Was the DNM rear shock over pressurised? Ive had that on an RCP2. All the others seem to be spot on.
  2. Sean9002

    Newbies First Build - 3000w Cyclone w/ 72v battery?!

    That incredibly shitty looking charger should be alarm bells for you! Cheap and nasty. :(
  3. Sean9002

    Mongoose/ Dyno CX24 200 Build

    It should do the job, the 48v will have some head room so your 52v pack shouldnt be an issue. You will need resistor going between the two large lugs (battery terminals) and a diode across the switching poles (the two small posts) On mine im using a 10k resistor and a 200v 3amp diode.
  4. Sean9002

    Mongoose/ Dyno CX24 200 Build

    Add a realy/contactor so you can switch high voltage with a low voltage switch. http://kellycontroller.com/contactors-c-32.html
  5. Sean9002

    Custom 5kW Vector (QS 205v3/Kelly/DNM)

    Welcome mate! keep us up to date :bigthumb:
  6. Sean9002

    My Chinese Ebay Build

    have you measured the steerer angle? it looks very steep, almost like a trials bike :shock:
  7. Sean9002

    Oset 24" build

    Haha, My thread has been kicked off again! love it. Love trials. I'll have to go back through and have a read about what everyones talking about. great to see some trials builds, I think theres only a few of us that have done such builds and theyre all usually pretty experimental. I see a few...
  8. Sean9002

    Mid Drive Steel Frame Bike 10kw Alternator Sunwin Controller

    Any idea what the weight will be at the end? I like this style of frame..the curved sections remind me of 'Pie Cuts' when welding up exhausts!
  9. Sean9002

    10 kW Giant Glory 1

    i run the same frame in! love the suspension on the Maestro frames :twisted: any reason your on an air shock instead of coil?
  10. Sean9002

    GNG / CYC X1 Pro 3000w

    So i had it right years ago when i was using spindle drive on my scooters =)
  11. Sean9002

    Switching shifter cabelling

    have you looked at griphsifts? run one upside down on the left side. its awkward but if your just shifting every so often it does work well!
  12. Sean9002

    Yz-EEB *5000w, 50mph, mx style*

    Looks way better with thte 888's on the front! that front tire looks a bit anemic compared to the rest of the bike now =)
  13. Sean9002

    Electric enduro frame

    can you explain that rediculous seat? It looks like it wouldnt be too friendly on the base of your "old mate" :lol:
  14. Sean9002

    Evolve Carbon AT with 50km+ range

    Of course this can be done, but you would be better off spending a couple of bucks on a new BMS specific to your task. If your going to build a battery (not a cheap process) do you want to risk it by skimping on using a BMS youve desoldered from another pack?
  15. Sean9002

    Motor became stuck on, on a DIY dual VESC e-board setup

    This might be a stupid question but it was the first thing that came to mind...are both VESC's running the same firmware? Ive had two that ive purchased at the same time, that were running different firmware.
  16. Sean9002

    New Boosted Boards

    Is your name sydney?....I ask because that site is registered to someone called Sydney...going by your username 'sydeskater'. Is it your site? if so, its polite to make a note of that. I like the layout of the site, keep adding content, maybe get some guest contributors and you could be onto a...
  17. Sean9002

    New Boosted Boards

    I think this is a DIY forum and theyre end user products... :D
  18. Sean9002

    Death Machine '17 cyclone3000 build

    Have you looked at Bell super 2r helmets? the one with the removable jaw section? They have quite a low profile and sure the lower may give way in a big impact but its dissepation of energy that would otherwise occur on your face =)
  19. Sean9002

    Self Driving Uber Kills Pedestrian

    When I worked in melbourne about 15 years ago a bike courier struck and killed a guy his estimated speed was about 35 kmh.
  20. Sean9002

    "Monster Board" High power 4X4 board with ATV tires

    Sub'd....this is gona be good :D
  21. Sean9002

    AussieRiders beach cruiser ressurected

    Nice one mate! Glad to see it being rebuilt. Now get out there and enjoy your summer :mrgreen:
  22. Sean9002

    OpenEbike - open source frame design

    reminds me of this build...I relaise this is more of a dirtbike than anything. not sure what ever happened to this project? https://grabcad.com/library/light-electric-dirt-bike-1
  23. Sean9002

    Mongoose XR-Pro Build

    You reported someone for giving you honest and accurate advice!? Ive had a bunch of people here point out my mistakes, Ive learned from them and ended up with a faster, safer, more efficient bike. Drop your gaurd a little bit mate, no one is here to prevent you from acheiving your goals, but we...
  24. Sean9002

    Laprise Board track racer

    Well done mate! :mrgreen:
  25. Sean9002

    Laprise Board track racer

    Where did you get the 'middle finger' key?
Back
Top