Search results

Date Relevance Most replies

  1. B

    Motor winding coating...

    Hello, I nicked a couple of motor windings while replacing some hall sensors. Any suggestions on what type of coatings to use for touch up? I thought about clear nail polish but I'm not sure i will hold up under temperature. THX, Brian
  2. B

    Solutions for 'blackenng' aluminum?

    Hi, I am intersted in some simple solutions for 'blackening' my aluminum parts...brackets, etc. I know there are various poducts that will blacken aluminum through a dipping process, but I'm wondering if anyone has any specific suggestions. I have considered the duracoat and ceracoat spray...
  3. B

    11 Speed chain strength on mid drives?

    Hello, I am considering moving to an 11 speed setup on my LR single stage build from my existing 10 speed setup. I don't care about the extra speeds as I only use the larger cogs. I want to move from a 42T rear cog to a 48T or 50T for better hill climbing with the single stage and I see many...
  4. B

    Motor sputter at higher RPMs...

    Hello, I am in the process of finishing a new build based on the LR single stage (small block) kit. I'm using a Powervelocity 12FET sin controller, and a CA3. I am running the throttle directly into the CA3 and only using the CA3 harness to the controller. I am running the CA3 in pass thru...
  5. B

    Torque throttle...CA3 or new controller?

    I'm currently runnng the Cyclone 3kw with the stock controller and a bafang thumb throttle. Although I'm used to the touchy throttle response, It would be more enjoyable if the throttle was torque based instead speed based. I understand the CA3 has some throttle adjustments, but is it a good...
  6. B

    Cyclone 3kw Yeti 575 build

    Here's my first ebike build. I used the Cyclone kit as a starting point, and machined new brackets, rewired the controller, and upgraded the drivetrain. For batteries, I'm running dual Multistar 16AH Lipos in a seatpost rack. The seatpost rack has extra support from a seatmount clamp, and the...
  7. B

    Cyclone controller hall effect/phase issue...

    I'm finishing up my Cyclone 3kw build and I'm having some trouble getting the hall effect and phase wire connections correct between the stock 40A controller and the motor. I rewired the controller using round multipin connectors, and although I was trying to be careful to maintain the original...
  8. B

    Sinewave controller for Cyclone 3KW recommendation?

    Can anyone recommend a good sinewave controller for the Cyclone 3kw kit. I will be running 48v at 40A max. I just want something that is known to work well. I expect to change most if not all of the connectors. thanks! Brian
Back
Top