Search results

Date Relevance Most replies

  1. S

    new cyclone 3000 w mid-drive kit?

    this is on a single speed system. it's all good, i'll probably just not adjust the amps unless I need to get more range since torque is more important than top speed
  2. S

    new cyclone 3000 w mid-drive kit?

    ah, thanks. I was actually hoping it would be the opposite, same rpm but more torque. guess not! So in general, amps have to do with torque and volts with rpm?
  3. S

    new cyclone 3000 w mid-drive kit?

    Does the "Battery current limit" value basically control how many amps are drawn from the battery? I have mine set to 75% with a 48v battery, which gives me 30amp * 48v = 1440w. If I switch to a 60v battery, and adjust the Battery Current Limit to 60%, that should give me the same 1440w...
  4. S

    Cyclone motor cutting out, just low battery, or something else?

    I had it set at 55, I adjusted it down to 50 and it was still happening despite the lcd display reading much closer to 60 than 50. Though I have noticed the bluetooth app will report a lower voltage than the throttle display. Maybe it was dipping below those voltages briefly. thanks, I was...
  5. S

    Cyclone motor cutting out, just low battery, or something else?

    I'm assuming this is just what happens when the battery gets low, but my cyclone motor with the 60a bluetooth controller started cutting out tonight if I would juice it too hard. If I released the throttle it would work again.. I didn't have to turn off the controller or disconnect the battery...
  6. S

    new cyclone 3000 w mid-drive kit?

    i'm curious too.. I thought the 4k motor was rated for 45a
  7. S

    new cyclone 3000 w mid-drive kit?

    I'm looking for some good looking 175mm ISIS crank arms that accept a freewheel and will clear the Cyclone 3000w with standard 68/73 bb. I see a lot of trials cranksets online but I don't want to spend $60-100 a pop to find out they don't clear the motor! Has anybody tried anything besides the...
  8. S

    Are there any 175mm ISIS cranksets that clear Cyclone motors?

    I'm looking for some crank arms that accept a freewheel and will clear the Cyclone 3000w with standard 68/73 bb. I see a lot of trials cranksets online but I don't want to spend $60-100 a pop to find out they don't clear the motor! Has anybody tried anything besides the stock crank arms that...
  9. S

    Resistor and Capacitor values for RC filter for Arduino throttle control?

    after messing around a bit, my recommendation is just get a mcp4725 DAC
  10. S

    new cyclone 3000 w mid-drive kit?

    this looks brilliant.. super clean, no need for a BB mount or a tensioner puller. I was considering buying the Luna 3D mount for $140 shipped.. instead I just spend $16 on two clamps and I'll shoot a friend some cash to weld them up for me. :bigthumb: :bigthumb: :bigthumb: btw what did you...
  11. S

    Resistor and Capacitor values for RC filter for Arduino throttle control?

    I saw in this thread, someone used a 1k resitor and a 10uf capacitor, I suppose I will start there unless anyone has another recommendation. Looking at these circuits in a circuit simulator it seems like the RC filter itself adds quite a bit of smoothing just on its own
  12. S

    Resistor and Capacitor values for RC filter for Arduino throttle control?

    I want to build a little throttle smoother using an Arduino. I've seen online that most controllers won't accept the PWM output from the Arduino and it needs to be converted back to analog using an RC filter. Can anyone recommend a resistor Ohm value and capacitor Farad value to use that...
  13. S

    new cyclone 3000 w mid-drive kit?

    Luna seems happy to stick with Bafang stuff and also their complete bikes. I think the cyclone market must be too small.
  14. S

    new cyclone 3000 w mid-drive kit?

    I really wish a better mount option was still available :( It also seems like support for cyclone in general has been falling off. A few years ago Luna came out with a bunch of Cyclone products, but most are out of stock and it doesn't look like they are going to get more.
  15. S

    new cyclone 3000 w mid-drive kit?

    I recently picked up one of these kits and have a few questions about the controller.. if anybody could help that would be awesome 1. Do you have to use a 3 speed switch (or jump the connections) to get the most out of the motor? I see when a 3 speed switch is not used, the controller...
Back
Top