Search results

Date Relevance Most replies

  1. S

    Sur-Ron - New Mid drive Bike

    I have tried another version. And it works now. It's made from POM and i used the magnets from a Pin Board. They are quite soft so that you can cut it with a knife. I hope the magnet will not slip off again. POM is not the best material to fix it on steel. I used super glue to fix it. In the...
  2. S

    Sur-Ron - New Mid drive Bike

    I have made my magnet sensor ring now. Was a hard work to keep the magnets in there holes before the glue did his job. They always are flipped out to the nearby magnets. The sequenz is ok now, the motor is running. But after i take in the motor and want to drive, the motor does only jerking. I...
  3. S

    Sur-Ron - New Mid drive Bike

    @Fechter, thanks for your Help. I have a CNC Mill and already created the 3d model. I am very curios if it will work afterwards. I will try a to use a Alu ring with tiny 2mm magnets. Since the sensor needs the plus and minus pole for opening and closing, I have to place them in alternately.
  4. S

    Sur-Ron - New Mid drive Bike

    I tested the Sensor it with a working motor from my friend. Here are only 2 two sensors are on at the same time. Thats ok. On my Motor, the entire sensor is working. All 3 positions are going on and off while turning. But on one position all 3 sensors are on. In the picture can you see the...
  5. S

    Sur-Ron - New Mid drive Bike

    Hi folks, I hope anybody of you can help me. My hall sensor magnet seems to be faulty. The magnet has slippet up in to the Hall Sensor. I have fixed the magnet with Loctite on the right postion again and i replaced the Hall Sensor with a new one. But i got the motor not running. My Nucular can...
  6. S

    Sur-Ron - New Mid drive Bike

    If you have a street legal version and just want to turn of engine stop and keep the break light active. Easiest way is to cut the green yellow wire which goes directly in to the controller and seal it up.
Back
Top