Thanks Amberwolf . I changed the title.
The batteries read OK using a load test meter, but they are old. Voltage reads 39 resting fully charged, 35 mowing ( 45 amps ) 32 when I take it back to the chatger and 35 after I shut it off to begin charging. I charge to 45 volts and it reads 39 after I...
The Etek motor on my converted riding mower has been working well but lately slows down while mowing up a steep hill. batteries read 39 start to 36 recharge. Cables, fuse and contactor show low resistance. The brushes are OK and it turns ( stiffly ) by hand. Everything looks good and it mows...
Thanks Amberwolf . tried switching the 5 volt supply to the throttle on and off with no sucess. The trottle has to be off then on irregardless. I had intended to use the elock to switch the blades on and off but that didn't work the throttle has to be off the on each time. I can't use a twist...
I have installed 2 Mophorn 3 phase 2000w motors as blade motors on my ride on electric mower. They need to run at a constant speed . Can I do this without using a throttle epoxyed to full speed ?
The ride on mowes at 45 amps split between the traction motor and the two deck motors. The blade motors areat about 10 amps each. That doesn't seem high to me but maybe I'm wrong.
The season is almost over here. Over the winter I'm going to enlarge the battery box to go from 55ah to 85ah.Maybe I...
I'm using 2 Unite 1020, 48 volt, 1000 watt DC brushed motors for the cutting blades on my Ariens Amp riding mower. The brushes have worn completely , ruining the commutator, in about 200 hours of mowing. Is this common ?
Thanks
John
I bought a 2009 Ariens Amp Rider mower a couple of weeks ago. It looks almost brand new and drives around fine. I have not been able to get the deck/blade motors working.
There are three wires into the controller besides the high current red and black. The orange is 48 volts when the key is...