Search results

Date Relevance Most replies

  1. M

    No regen with Baserunner

    Hello, Just to mention that it is also described under section 6.6 in the Baserunner V4 manual. Also, if the BR is to be used with a Cycle Analyst, see section 3.1 of the manual. The supplied adapter cable that plugs in the MAINS and has a 2 pins connector at the other end serves the same...
  2. M

    Baserunner + Grin All-Axle Motor settings

    Hello, I had the same issue previously with a Phaserunner and a RH212 from Nine Continent. Grin response was similar about the PLL and co. Since I was in a hurry I decided to go in extremes and cut in half the values in order to see a real difference. It paid out when I went on the low side...
  3. M

    New BBSHD Temperature Sensor? BBSHD + Phaserunner + V3 setup

    Today, I replaced the original thermistor with a 10k thermistor from Grin. The operation was simple and the acces to the thermistor is easy once the stator's removed. To fix the thermistor to the stator, I used Permatex Ultra Black sealant. Since it's not full of acid like other RTV silicones...
  4. M

    New BBSHD Temperature Sensor? BBSHD + Phaserunner + V3 setup

    I have the same issue. The older BBSHDs had a 10K thermistor. I wrote to Grin about that andit seems the nes BBSHD have a new type of sensor. They had a few complaints but have no solution for now. Since I'm doing the bike for someone else and lack the knowledge to figure it out, I will put a...
  5. M

    Baserunner L10 - Current Scaling error

    It turned out the Baserunner was replaced and now everything works fine.
  6. M

    ME1306 From Zero motorcycles

    Yeah, the thing that messed me up was that the connector has 2 combined green wire, which i just learned from the encoder datasheet, is the shield and from Kelly's support tech, it does not need to be connected. thank you for your input, I have a somewhat basic knowledge in electronics your...
  7. M

    ME1306 From Zero motorcycles

    I had some support from Kelly and they say that the "Hall C" is not used. I just unplugged the wire. Their manual is not well made since it's after the identification procedure that they specify that we need to manually input the sin/cosin amplitude values. I was able to find out that Zero uses...
  8. M

    ME1306 From Zero motorcycles

    Hello, I got 2 FXS motors (ME1306). I'm not really familiar with the Sine/cosine encoders and I would like to hook up a Kelly 8080ips series to it. Unfortunately I'm not able to identify the encoders wire. The documentation from the web and moternergy does not seem to match when I tested it...
  9. M

    Faulty baserunner?

    Did you have any news from Grin? I previously had a similiar behaviour with a G310 as well. Now, I got a similar issue with a Bafang G60 on a fatbike equipped with a Baserunner too. The difference is that all my hall sensors are good. I installed 3 other Baserunner with direct drive motor...
  10. M

    Baserunner L10 - Current Scaling error

    I got the same problem here. I have been told by Grinn that the current sensor is a Hall effect sensor and to make sure nothing magnetic is close to the BaseRunner. The issue disapeared and then reappeared after a few weeks. The bike's frame is a carbon frame and the PAS sensor is 4'' away from...
Back
Top