Search results

Date Relevance Most replies

  1. F

    frosted.coot.scoot's Bird2 Scooter Question Thread

    SO I finally got the charger in from Amazon. Its an 84W 42V Charger and I started charging my first battery pack. After 7 hours however I am only getting like 6.23 Volts across the out put XT60. What could cause this to occur? I have followed a build video with great attention and my battery is...
  2. F

    frosted.coot.scoot's Bird2 Scooter Question Thread

    Well it seems as though it was only a simple wiring misake that was causing my problems. I had used the wrong combination of wires on my throttle circuit. After substituting the yellow wire from the throttle instead of the blue wire that I had previously used, my throttle was fully functional...
  3. F

    frosted.coot.scoot's Bird2 Scooter Question Thread

    My apologies for the tone of my last post. I often get engrossed in what im so anxious to learn about that I lose contact with my sensabilities. Moving forward. Indeed I do have a link for the controller I purchased. Here it is...
  4. F

    frosted.coot.scoot's Bird2 Scooter Question Thread

    I sincerely apologize for my gross lack of proper forum etiquette. I have never used a forum or anything similar before. I have certain challenges to learning in that a perfunctory read through of rules, regulations, and guides do nothing for me. I lack the ability to spatially reason, and as...
  5. F

    frosted.coot.scoot's Bird2 Scooter Question Thread

    I recently wired a MNTT 36/48V brushless motor controller on a bird 2 scooter I bought at Auction. After wiring the throttle up, I went to test the throttle and found that when I depress the throttle the motor starts turning the wheel but there is no variability. The motor also continues to run...
  6. F

    frosted.coot.scoot's Bird2 Scooter Question Thread

    I recently wired a MNTT 36/48V brushless motor controller on a bird 2 scooter I bought at Auction. After wiring the throttle up, I went to test the throttle and found that when I depress the throttle the motor starts turning the wheel but there is no variability. The motor also continues to run...
  7. F

    frosted.coot.scoot's Bird2 Scooter Question Thread

    I recently picked up a decommisioned bird 2 scooter and am in the porocess of conversion. I went to measure the voltage on the output on the XT60 that connects to the controller main powersupply and I noticed that the voltage immediately began dropping. It was steadily going lower and lower...
  8. F

    frosted.coot.scoot's Bird2 Scooter Question Thread

    Can someone please help me to kniow where i wire the charging port wires to a 350w 36 volt mntt brushless motor controller.
Back
Top