Hello EV community
I'm a mechanical engineer student from switzerland and for my final thesis I'm building an e-motorcycle.
I have a problem with getting the motor to turn. The only reaction I get is a noise when twisting the throttle.
I tried out so many things for days now and set all back to original state. The Gen4 came with the actual software and firmware and dfc for the me1616. But the only thing that happens is some noice when I turn the throttle...
No errors, contactor clicks, analog input is okay(throttle), I/O set and active(FS1, ForwardSwitch, SeatSwitch).
Now I turn the throttle the motor seems to vibrate very little, nearly unnoticable but with a noice(not too loud, as if it wanted to try to turn). All wiring should be okay, according to the wiring diagram of sevcon for single traction systems. I double-checked the sin/cos but it's connected properly.
I have a power supply with 80V and 50A attached to the controller. I didn't align the encoder
I would apreciate any help.
-Alessio
I'm a mechanical engineer student from switzerland and for my final thesis I'm building an e-motorcycle.
I have a problem with getting the motor to turn. The only reaction I get is a noise when twisting the throttle.
I tried out so many things for days now and set all back to original state. The Gen4 came with the actual software and firmware and dfc for the me1616. But the only thing that happens is some noice when I turn the throttle...
No errors, contactor clicks, analog input is okay(throttle), I/O set and active(FS1, ForwardSwitch, SeatSwitch).
Now I turn the throttle the motor seems to vibrate very little, nearly unnoticable but with a noice(not too loud, as if it wanted to try to turn). All wiring should be okay, according to the wiring diagram of sevcon for single traction systems. I double-checked the sin/cos but it's connected properly.
I have a power supply with 80V and 50A attached to the controller. I didn't align the encoder
I would apreciate any help.
-Alessio
