TSDZ2, no drive - "torque fault"

[raylo32]

Well, I busted my TSDZ2, just doing a routine blue gear greasing. I've had this thing apart many times before with no issues but this time the display boots up showing "torque error" on the bottom of the screen and there is no motor drive when pedaling. The motor does run normally in walk mode or cruise control, however. The only wiring I touched was that one flat connector and the main motor wire terminals... and put back exactly the same way. And I did not take apart the right side of the motor where the torque sensor lives. Anyone have any hints on how best to diagnose what might be the problem?

 

[raylo32]

Never mind, I found the problem. Whilst manipulating the motor and wires I seem to have broken the red wire going to the torque sensor connector. I'll have to pull the motor and controller to get in there to try to splice it together. Hopefully it broke in an exposed part. If not, I am screwed. Tomorrow...