+ 1 Getting tired of trying to get the programing right, the chain line right and hence the shifting reliable and now getting the right crank arm off ... One more set of attempts to get this right and if it does not work it will go the market to be replaced by a MAC rear hub build.
Andrew
I am getting an Error 21 this morning which I know is the speed sensor. Initially the sensor light was lighting up, so I know it was getting power from the motor and magnet is very close and it would in hte first couple of attempts at resolving the problem fire up the sensor but then on about...
Thanks. Does this bring the chain line closer to the frame or further out or no change? I am looking to see if I can bring the chainline a mm or two closer to the frame.
Andrew
Working through some basic checks:
(1) Battery charge?
(2) Output from battery correct?
(3) Voltage correct on output side of the power cable from the battery?
I had a similar experience and it was caused by voltage drop, i.e., bad connections. I would be checking carefully all connections...
I use them with a Bafang BBS01. I have them effective and haven't been aware of any time when it has not worked, however I have had a couple of times when they cut off the motor all by itself: unplugging the cable to the controller and re-plugging it reset everything. It has not done it for...