Dui ni shuo de dui's latest activity

It feels good to have the time to work on the bike again. This morning I made these bits: I turned an M12 (should have been a 14 or...

I'll explain some of the settings so you can tweak them later if you need, as I didn't have the time yesterday: Cell high protect : I...

If you copied all the settings I gave you in the app then the balancing should start automagically during the charge.

I contacted ANT and they sent me this picture to follow. Apparently this is the correct wiring. Going to work on it now. Thanks for...

Correct both of you, my bad, I miss-typed in my response, I did mean to type switch

The only time when you have to press for 6 seconds is when you want to work on the bike. The rest of the time you just turn the key...

I think this is because you aren't using it in a 24S configuration. In which case you need to connect the wire at the far left, the blue...

pictures would help.

it's almost correct, but the wire labeled 1 should be the black, ground wire. So the 2 should become 1, 3 becomes 2, and so on. The last...

I based the figures from this page, showing the specs of the leafs cells, especially for the discharge and charge curves...

That should be a good start:

Ah also can you provide the datasheet for your cells?

It would be a lot better if you could share screenshots of your current settings. We could edit the image and then you'd just have to...

Ah ok in the hypothesis that there is a service breaker before the contactor then there won't be any problem while working on the bike...

I think it does, but not 100% sure. The ant BMS has a screen and I think it sends data from and to it via UART.