Smurf2

This Stuff is pretty good for finishing off the cable job it just takes patience winding it neatly around the cables.. looks...

Ok. I am finished. Want to know your thoughts abut this, but be gentle please :) I took a time. I thought a lot about how I would...

fwiw and while im sure you know, just in case... marine heatshrink is a thing and contains 'glue in the sleeve to provide an extra seal...

I have a lot of normall heatshrinks. But never heard that exist glued version. Good to know for buying next time. Thanks. EDIT...

Yes looks good,hope its as grand ride for you

Thanks @docw009. I expected if I will have "+" on upper right Positive, then Signal wire will also show me "+" and will be separated...

Probing the throttle always is confusing, In your diagram, bottom center is ground. Top right is power. The signal pin will be top left...

Guys, please one more time. I had searching for tutorial, but nowhere find this situation. This is harness side, side from controller...

Yes. I checked again continuity of two 3-pin connectors for sensors. Both share same 2 pins (signal and ground) except third which not...

. . . . Is anyone knows should both lights be on when I pull only one cable on the sensor? . . . .

You had the two wire magnet sensors working before? The new ones seem like more trouble than than they are worth. . I thought they used...

Ar Im still unclear 'open jack from the battery' are words? perhaps its a locally known idiom ? Just like the brake:low on the label...

No. Only had one istalled on right side. Other one is in package. Yes, exactly. But they are nice 😥 And on old one sometimes I remove...

Here is the final test before I assemble all. At first, working like a charm! With throttle too. But something strange. Tell me are...

I suggest you do it this way, as you don't know where the 3rd pin on the harness brake plug really goes, That way, you are not running...