Recent content by TimV

I set the 25km/h limit on "on" in the display, but did nothing. If I enable on startup in the configurator, then it is always on when I turn the system on?

If I aim in the wrong thread, please let me know. I have used the tuning fork from emmebrusa. Here are my settings. What did I do wrong, if I set it to street mode with 250W and 25km/h speed limit on the screen, it does nothing. It still has full power and goes above 50km/h. Going to drive a...

Your welcome

For flashing the motor you need to use the speedsensor cable from the motor. For flashing the vlc5 screen you need to use the connector where you plug in the extra buttonconnector on the screen with power, i button and + and -. You dont use the cable between motor and screen.

For making the programming cable. I only find sources in china that have the Tongsheng speed sensor extension cable. 1 to 3 months shipping. It looks like the bafang/8fun pogramming cable is the same connection. Will that work or not? Do I still need to hack that cable up and buy a st link? (Or...

I dont need huge power. Just enough to support me. I have bought the 36V 350W version. I have a lot of 36V ebike batteties with a dead bms. So only need to invest in a bms. I want to keep it as simple as posible. And will not buy another screan. I will use the fork and reflash the stock software...

Question, even with the opensoftware from here, there is no way of setting the 45km/h limit higher? I aim putting the Tongsheng in a velomobile and when I pull a race, I go over 55km/h. Would be nice to still have support over 45km/h.

The Versatille has an trailer hitch already for a double wheel trailer with 1 single arm. At the low powers I plan to use, I don't think jackknifing is a problem. Most of the roads are straight. And the corners are sharp, I let the bike roll out. In fear of tipping over. If i use a cranck...

Trying to fix the Velomobile. It looks like I aim going to make a pusher trailer. Double hub motor with throttle. And pedal sensor. So it is pedal assist with option to use throttle when wanted. What hub motors are reliable? Direct drive or geared hub motor? And have specs to go 50km/h on an...

Yes. But the bafang construction makes the total with way to wide. The middle plate is only 4cm wide. And we cant go wider or we cant pedal at all

Not yet. Currently i aim laying the last hand on renoveting my new home witch i will move to this summer. So it is going to be a project for the next winter.

An crankshaftmotor is unfortunately not going to fit. Here you can see that it will be to wide.

This winter is the conversion happening. I have build an 48V (14series lithium) batterie and has 20Ah. I aim going to buy an 48V controller and a motor with a sprocket with freewheel. But what motor should i buy? I aim shooting for a 250 - 350W motor that i will push to piek 500W. Its a motor...

I probably going to use the outside of the motor. The rear tire is an 40-406 tire. But tire diameter does not affect top speed. Top speed depends on load and motor rpm and motor diameter.

Hi I aim building an friction drive to help me accelerate my velomobile. The question i have is what motor to use? I will run on 8s lipo and top push speed should be between 45km/h and 50km/h. Going to use an 8s lipo 150A continius sensored/sensorless mode ESC. (Not have bought it yet)...