Recent content by zooz

Just answering my own question. Thanks to Alex, I have the pinout now for the BMS connector on the controller end. The picture below shows an inside of a connector where soldering goes.

I can use the same connector. I need to know which wire on the controller side goes to which connector pin.

So, I have a problem. I tried searching this thread with no luck. I have ripped the BMS connector off the controller side due to ridiculously short cables that Adaptto does and obviously my lack of carefulness. Does anyone have a pinout for the BMS connector on the controller side? Thanks in...

I am in the process of building a new battery pack for my Q76R frame and MAX-E. I calculated that I can easily fit 180 cells using spacers. That will give me a nice pack of 20S9P. Given that a single VTC4 can burst at 30A, nickel won't cut it. I tried various options: - Solder copper wires to...

Thanks. Simple is best. I'll go with 19mm shaft with a keyway, I believe they are 3/16" (4.76mm) keyways. Given the above, there are rear sprocket matches for different chains, so that won't be a problem.

Hello, I am starting a new EV project, which is to build a rather powerful go kart. I have started looking for a 20kW+ BLDC motor, I am leaning towards Revolt RV-160pro. However, I need your help to determine what sort of motor shaft type I should go for? Revolt can make a custom motor shaft...

Hey, have you managed progress on your build? I am building/converting a go-kart and also looking at Saietta brusless motors, I emailed them, but still waiting for reply. Have you had much luck talking to them?

Hey, I was setting up the controller for the first time. I did a system reset and everything is working fine. Thanks for a quick reply.

Hello, My adaptto max-e is stuck in Brake mode. I tried disconnecting throttle, but for some reason the display shows Brake. Even then I connect the charge it still says brake. Please see attached picture.

Here is how to connect an odd number of cell groups in series to an Adaptto BMS. Related topic: https://endless-sphere.com/forums/viewtopic.php?f=2&t=61183#p914204

Thanks for the info. I actually found a diagram made by Adaptto people which explains how to wire up 13s to Adaptto BMS.

Hi All, I just built a temporary 13s14p li-ion pack for my new ebike. I have an Adaptto MAX-E with BMS. After reading online, looks like Adaptto BMS only supports an even number of parallel groups, as in 12s, 14s, 20s, etc. I am planning on building a much more powerful pack later on, but right...

I am about to purchase new cells for my battery pack. What cells would you recommend?

How long does it normally take for Qulbix to manufacture and deliver a Q76R frame?

Do you seriously believe in what you just said? :-) Do you still think that spam bots still work that way?