Recent content by zorbas

I wanted to give a little feedback after a few months of testing. I resolved my issue by simply insulating the L1019 connector (Hub to controller) with electrical tape. It's as simple as that. I realized my issue was coming from the contact of that connector to my bike frame, after keeping the...

Thank you for these insight to my problem and the suggestions for investigations. I'll test that and hopefully find out the origin of the issue (fingers crossed). I have already removed a dodgy connection from the system and detached the controller from the frame (it's now hanging in a bag)...

Thanks for this suggestion amberwolf. I did the check and evrything seems fine. I also tested the throttle and the pedal sensor and both trigger a response and make the hub turn. As I said, I only get this fault when I connect the -tive side of the battery to the bike frame. Besides the issue...

Anyone who could help ? I did what is suggested on Grintech site with no positive effect. " Instantaneous Phase Overcurrent Fault (2-2 Flash): This is a fault that typically occurs when there is a sudden change in the motor eRPM (such as hitting a pothole, or the motor transitioning from open...

Hello, I read this thread because I have a similar issue with my set up. I connected the -ve side of the battery to the frame. And now as soon as press the throttle, I have a fault with the phaserunner. It says "Fault 9 Instantaneous phase over current". Did I do something wrong on the wiring? I...

I really like the idea :-)

Most Torque sensors will fit 68, 73, 100mm end even longer. This is not only about the length. It's about the size of the cup (the diameter of the BB shell) and how the BB it is mounted to the frame as well (ex: BSA are threaded, PF41 are press fit). The adaptor for BB30, PF30 will work for...

Thanks I went there and couldn't find anything else than threaded BSA type bottom bracket sensors either. Interesting forum however. I will keep reading.

Thanks for the suggestion. That was an interesting information. Unfortunately the BB86 would not fit into this adaptor. Plus the adaptor is made for bafang bottom bracket, not for the Threaded BSA type Torque sensors like the erider, NCTE.. It seems all BB sensors are threaded and BSA type.

I do not have additional information. The question is « are there any Bottom Bracket torque sensor for BB86 ? »

Grintech might have an answer. I order my equipments from them most of the time and they currently don't sell what I need. For the moment, I am asking here. :wink: I couldn't find anything using google either so I am hoping others might have done the same research more successfully or might...

Looking for answers to my current problem, I found this discussion and I find the title quite suitable. I hope it's Ok if I use it :-) I am investigating the possibility to electrify a gravel bike with a "large" bottom bracket cups. Do you know if any BB torque sensor for BB standards like...

The dealer who sold me the hub and the spokes told me not to worry too much about it too. There is a shortage with the e-Strong Sapim spokes and so I will wait a while and check the state of my wheel regulary. I have been riding approx 50 km with it with no signs of weakness in the wheel so far.

I have built a new wheel with a RH212 9C motor and since then, I have no issues at all with the dislay screen. I believe the problem was coming from the GMAC motor.

Thanks ZeroEm, yes, I think I will rebuild it with a new set of spokes. It should look like the picture below. The current build is worrying me too much.