chilltrout
10 W
- Joined
- Oct 30, 2016
- Messages
- 78
Ok so it turns out that it was the gnd cable in the CA plug on the controller side!!!!
It had blown in half! wasn't even a trace!
But now the controller is doing strange things and I think one of the groups of fets are dead
I forgot to mention that when the CA died it went wide open throttle and ended up running into a wall and the motor locked up, it still spun this time when I got the CA working again but probably spun for 30 sec and then controller failure. (wheel cogging etc, only on 1 phase in 1 direction)
It had blown in half! wasn't even a trace!
But now the controller is doing strange things and I think one of the groups of fets are dead
I forgot to mention that when the CA died it went wide open throttle and ended up running into a wall and the motor locked up, it still spun this time when I got the CA working again but probably spun for 30 sec and then controller failure. (wheel cogging etc, only on 1 phase in 1 direction)