I have just wired mine in, i get the throttle slider going up and down but no motor?
![Shock :shock: :shock:](/sphere/data/assets/smilies/icon_eek.gif)
i have set the ramp down to 001 so i will go and change that.
I only have the DP connector between CA and controller, do i need to use the original controller throttle input wire? I am seeing over 4v on the green wire in the DP connector with a closed throttle so i presume the controller has shut down because the start voltage is too high on the throttle wire, or am i wrong?
I have set the voltages for input and out put below the actual min throttle output and the actual voltage the controller needs to start, i didnt know i could read them from the CA so i can do that aswell.
Been and made some adjustments,,
My throttle min output voltage is 0.85v so i set the min input to 0.87v
max input displayed by the CA is 4.19 so i set this to 4.10v
Min out put is set to 1.40v as i know the controller does not start til just above this voltage (even tried stting this to 0.40v)
Max out put is set to 4.10v.
Ramp up set to 500, ramp down to 999.
When i look at the throttle display screen, if i just open the throttle a little the bottom left read out starts to rise untill it max's out even with the input voltage only showing 0.9v, is this correct?
I still dont have any drive, i have the tried speed and current settings aswell as pass through, no drive? what am i doing wrong?
I should stick to hammers and welding!!
Simon.