zlatkomas05
100 µW
- Joined
- Jun 13, 2022
- Messages
- 7
Hi there i have for while and i couldn't figured what's the problem. I have modified bionx brushless hub motor with new hall sensors 48v 20ha (max current 35A) battery and i have two controllers one 1000w and other 1500-3000w with max current of 45A. I have this hub more then 2 years. I have replaced the hall sensors a month ago and suddenly i got other problem.
The wheel is spinning only when it's lifted from ground with max speed. But when you put it on floor it try but like no enough torque and it couldn't make one rotation .
I checked all hall sensors seams working the voltage of sensors going on/off( 5v/~0v). Check wire losses but nothing visual i could notice. Please help for advice what could be. Thank you in advance
The wheel is spinning only when it's lifted from ground with max speed. But when you put it on floor it try but like no enough torque and it couldn't make one rotation .
I checked all hall sensors seams working the voltage of sensors going on/off( 5v/~0v). Check wire losses but nothing visual i could notice. Please help for advice what could be. Thank you in advance