Nate
100 mW
Ok, I'll wait on the gate driver. I have one or two of every part arriving tomorrow so I could replace whatever needs it. I hope we can figure the part(s) out.
All the readings on the shunt resistors are the same as the battery connections at about 3.75v. Which makes sense x 16 = 60v... The reading of 16v came from the ground just below the any shunts line... I managed to blow a trace on the bottom from shorting #4 battery to shunt 3. :x Dammit!
I repaired the trace and the readings seem the same. Could that damage anything else?
The BMS is pulling .6-.8a from the charger. Were you referring to this or do I need to test the amps between each channel?
*Edit: Just tested - Each channel reads about .6a... and the LED turns off for that channel during the test.
I know how frustrating it is to troubleshot without the hardware in front of you, I work in IT. If we can't figure this out soon I may take you up on that offer. It is just so darn close... Thanks again.
All the readings on the shunt resistors are the same as the battery connections at about 3.75v. Which makes sense x 16 = 60v... The reading of 16v came from the ground just below the any shunts line... I managed to blow a trace on the bottom from shorting #4 battery to shunt 3. :x Dammit!
I repaired the trace and the readings seem the same. Could that damage anything else?
The BMS is pulling .6-.8a from the charger. Were you referring to this or do I need to test the amps between each channel?
*Edit: Just tested - Each channel reads about .6a... and the LED turns off for that channel during the test.
I know how frustrating it is to troubleshot without the hardware in front of you, I work in IT. If we can't figure this out soon I may take you up on that offer. It is just so darn close... Thanks again.