Triace99
1 µW
Greetings!
I have a bunch of bikes and scooters that I have to finish for some clients and I have a scooter that absolutely needs to be done within 24 hours.
I am pretty experienced with modifying e-bikes but scooters are a diffferent beast to me, especially dual anything.
Unfortunately, the scooter was disassembled due to a rats nest and horrible wiring but I was hoping the forum could help. I did extensive research but it’s tough to find anything.
Any help would be greatly appreciated, perhaps even payable for their services and help.
there’s an “a” and “b” controller which I assume is front and back.
There’s a single 60v battery with 2 xt60 plugs and I got to the point where I have the power, hall sensor wires, and phase wires connected with the brakes.
I need to wire up a throttle and display (optional), lights/turn signals/blinkers, speed controller, not sure if I’m forgetting anything else.
I just need to get it to the point where it can move at all. One motor/two motors/ whatever. Then I can finish later on.
Maybe it’s best to just hook up one motor and controller first?
I have a bunch of bikes and scooters that I have to finish for some clients and I have a scooter that absolutely needs to be done within 24 hours.
I am pretty experienced with modifying e-bikes but scooters are a diffferent beast to me, especially dual anything.
Unfortunately, the scooter was disassembled due to a rats nest and horrible wiring but I was hoping the forum could help. I did extensive research but it’s tough to find anything.
Any help would be greatly appreciated, perhaps even payable for their services and help.
there’s an “a” and “b” controller which I assume is front and back.
There’s a single 60v battery with 2 xt60 plugs and I got to the point where I have the power, hall sensor wires, and phase wires connected with the brakes.
I need to wire up a throttle and display (optional), lights/turn signals/blinkers, speed controller, not sure if I’m forgetting anything else.
I just need to get it to the point where it can move at all. One motor/two motors/ whatever. Then I can finish later on.
Maybe it’s best to just hook up one motor and controller first?