cubicapple
10 µW
Hi all,
My Benelli e-Misano has a cadence-only PAS. I want to upgrade it to a torque sensor. The bike doesn't have a throttle, uses the Lishui LSW1010-17F controller and the Bafang C965 lcd display.
I have read through the relevant posts here and I understand that my options are the following:
My Benelli e-Misano has a cadence-only PAS. I want to upgrade it to a torque sensor. The bike doesn't have a throttle, uses the Lishui LSW1010-17F controller and the Bafang C965 lcd display.
I have read through the relevant posts here and I understand that my options are the following:
- Non-CA:
- plug the torque/cadence sensor to the existing controller if possible OR
- replace the controller by the one which supports the torque sensor
- CA or like:
- upgrade to CA or MPe from bikel.pl and use the existing controller if possible OR
- replace the controller by the one which supports the throttle input
- can I plug a torque/cadence sensor (e.g. ERider T-17) into my LSW1010-17F controller? Maybe by soldering in some extra wiring?
- if yes, do I have to (or ought to) flash the open source firmware?
- If not, any advise on which one to buy which works with torque sensors?
- any chance my controller supports the throttle input that I could use with the CA?
- if not, any advise on which one to buy to use with the CA (I understand it must be a 'dumb' throttle only controller)?
- does anyone have any experience with MPe from bikel.pl? Can I use it with my exiting Bafang C965 lcd display?