Multipin connector for BMS?

[Swe]

Hi,
I have Adaptto BMS, that have 5-pin connectors for each 4S group. I dont want to solder them directly on battery so I need some connectors between them. What type is best to user here? See my attached picture how I want to do (wiring not correct).

I need like 14 1-pin connectors from each group. Red ones in the picture named "Connector 1". Then one large connector with more than 14 pins, named "Connector 2". What connectors should I use? I think I somewhere have seen a connector lika a computers printer port, but is really okay with current and voltage...?

I have the BMS and the wiring to connector 2. But Connector 2 and the rest I dont have.

 

[Swe]

Can I use a DA-15 connector? 15 pin sub contact.

https://en.wikipedia.org/wiki/D-subminiature

It is not much current going through BMS, am I correct?

 

[Sunder]

JST-XH 14S would be the industry standard for battery to BMS connection

http://www.ebay.com/itm/14S-JST-XH-2-5MM-15PIN-Connector-balance-wire-50CM-Cable-CellLog-18650-battery-/181975435133

If you need both ends, you can buy an extension cable and cut it in half. Can't see any on ebay at the moment, but I've bought them before.